How To Setup and Programming Endress+Hauser PROSONIC Clamp-On Ultrasonic Flow Meter

Do you familiar with ENDRESS+HAUSER brand?This time I would like to share about How to setup and programming the PROSONIC Clamp-On Ultrasonic Flow Meter.Also I have attached with video from ENDRESS+HAUSER,method and detail step how to setup the program for PROSONIC Clamp-On Ultrasonic Flow Meter.It very user friendly and easy to setup.

This is basic information about Endress+Hauser Prosonic Clamp-On Ultrasonic Flow Meter :-

The measuring device described in these Operating Instructions is to be used only for measuring the flow rate of liquids in closed pipes.
Examples:
• Acids, alkalis, paints, oils
• Liquid gas
• Ultrapure water with low conductivity, water, wastewater Read More

How to use a clamp on meter?

In electrical field,current (ampere) is very important value.It very useful to sizing the circuit breaker,sizing the electric cable,for troubleshooting guideline and many more.Without ampere value,we cannot get the best result for sizing or design.

How we can get a current value?We can use the ammeter or clamp on meter to measure the current value.If you remember in last post AC DIGITAL CLAMP ON METER,ampere must be measure in series circuit to get the value.Now for easy current measurement job,we use a clamp on meter.

I explain detail on my video how to use the clamp on meter.The important thing is we must safety first.Make sure the distance of  live conductor must in safe range.always beware when u perform the measurement job using the clamp on meter. Read More

Troubleshooting For Electronic Circuit

For maintenance or electrician,troubleshooting can be a very financially rewarding and personally satisfying.The good troubleshooter has a advantage and proper understanding of electrical or electronic ,hand on skills and problem solving techniques.Troubleshooting is an art.It need creativity and passion to become the expert.

Electronic devices or equipment contain similar component in their circuit board such as transistor,diode,capacitor,resistor,ic,relay,connector,wire and etc.We must understand deeply the component characteristic,common fault for these component,and how to test and verify their condition. read more