How IoT Is Redefining the Future of the Electronics Industry

As an increasing number of devices get connected to the cyberspace, we are embarking on a new journey towards creating a fast-paced industry called the Internet of Things (IoT). In 2015, over 15.4 billion devices were connected to the internet, and the Information Handling Services (IHS) predicts that this number will go up to 30.7 billion by 2020. According to General Electric, IoT will add $10 to $15 trillion to the worldwide GDP growth by 2030.Thus, it is time for companies to think about the long-term implications of IoT on their businesses.The Internet of Things refers to a connected network of devices with an on/off switch to the internet. These devices can interact with the environment and other devices that are a part of the same network. Read More

How To Disconnect THOMAS Coupling From Induction Motor Hub?

Hi,

This post I would like to share video how to disconnect or dis-engage THOMAS Coupling from motor hub during maintenance works.In this video,technician plan to replace new bearing for the motor due to abnormal sound detected from bearing.Normally in industry or chemical plant,Thomas Coupling is the one of common application to connect electric motor as a drive and pump as a rotary equipment for the process.

The main reason why Thomas coupling are used :-

  1. To transmit power from one shaft to another, efficiently and effectively.
  2. To accommodate slight shaft misalignment which develop in service.

Thomas coupling application also can protect our equipment from mechanical damage and misalignment. Below several protection when using Thomas coupling :-

1. Absorb shock, vibration and pulsations.

2. Decrease cross load on bearings.

3. Accept load reversals.

4. Minimize backlash. Read More

How To Setup and Programming Endress+Hauser PROSONIC Clamp-On Ultrasonic Flow Meter

Do you familiar with ENDRESS+HAUSER brand?This time I would like to share about How to setup and programming the PROSONIC Clamp-On Ultrasonic Flow Meter.Also I have attached with video from ENDRESS+HAUSER,method and detail step how to setup the program for PROSONIC Clamp-On Ultrasonic Flow Meter.It very user friendly and easy to setup.

This is basic information about Endress+Hauser Prosonic Clamp-On Ultrasonic Flow Meter :-

The measuring device described in these Operating Instructions is to be used only for measuring the flow rate of liquids in closed pipes.
Examples:
• Acids, alkalis, paints, oils
• Liquid gas
• Ultrapure water with low conductivity, water, wastewater  Read More

Motor start and run capacitor

Application of start and run capacitor for single phase motor.

Why we applied a capacitor for single phase induction motor?The reason is to improve performance of motor by generate the rotating field.Design for this motor have a two ( 2 ) stator winding,and one of it is the auxiliary and is connected by a suitable capacitor size.

The capacitor increases the starting torque and the full load power as the current flowing through the auxiliary winding, de-phased by the capacitor, creates a rotating field.The voltage across capacitor usually higher than the mains supply.

The choice of the capacitance is usually empirically made on the motor. This is because of shuttle differences between motor manufacturers.As the torque and the power of the motor also depends on the reactive power of the capacitor. read more